Introduction

(translated from French via Google)

The following document describes the steps necessary to update the USB box accessory software version V2.0 to version V3.01 software.

To achieve this operation, it is necessary to have:

-- A standard PC,
-- A USB key 2MO minimum,
-- From V3.01 software for USB box: the file "USPA_UPD.ROM" accompanying the instructions in the same file "USBbox_V3-01.zip"
-- Files GW_CFG.BIN, GW_CFG.CFG and test.mp3 accompanying instructions in the same file "USBbox_V3-01.zip".

Note: These operations must be "engine" to stabilize the voltage of the electric vehicle.

Step 1: Testing the software version in the box.

-- Copy on a USB key blank, the files GW_CFG.BIN, GW_CFG.CFG and test.mp3 (from file USBbox_V3-01.zip)
-- Turn on the car and put a radio mode,
-- Insert the USB key in the box and then wait 30s,
-- Check the contents of the key on the PC.
-- Two additional files were created (GW_DBA.BIN and GW_EES.BIN) and a directory whose name must be USPA2_00. This confirms that the version of the software installed USB box is the V2.00, otherwise please contact support network
-- Empty the contents of the USB key.

Step 2: Update USB box.

-- Copy the file USPA_UPD.ROM on the USB key virgin (from file USBbox_V3-01.zip)
-- If you have not already the case, turn the car and put it into radio mode,
-- Insert the key in the cabinet,
-- Wait 2 minutes, then remove the key,
-- Check the contents of the key on the PC,
-- The file has disappeared from the key.

Step 3: Controlling the update.

Repeat Step 1 to verify the successful completion of the development software. The version of the software box USBbox is the name of the directory that was created on the key ie USPA3_01 to V3.01.